AISI1045 steel was modified by laser heat-treatment and conventional heat treatment. The friction and wear behaviors of the steel specimens after various surface modifications sliding against SAE52100 steel under the lubrication of liquid paraffin containing sulphurized olefin were comparatively investigated on an Optimol SRV oscillating friction and wear tester. The worn surface morphologies of the modified steel specimens were analyzed using a scanning electron microscope. The elemental compositions and chemical states of some typical elements on the worn surfaces of the modified steel specimens were analyzed with an energy dispersive X-ray analyzer and X-ray photoelectron spectroscope, respectively. It was found that the laser heat-treated specimen showed the highest hardness and best wear-resistance. The laser heat-treated and conventionally heat treated AISI1045 steel specimens sliding against SAE52100 steel under the lubrication of liquid paraffin containing sulphurized olefin registered smaller friction coefficients than under the lubrication of liquid paraffin alone. This was partly attributed to the increased hardness of the modified specimens. The tribochemical reaction between the steel and the active elements in the additive was involved in the sliding of the modified steel specimens against SAE52100 steel ball under the boundary lubricating condition, with the formation of a surface protective film composed of various tribochemical products. This also contributed to improve the friction and wear behavior of the modified steel specimens. The steel specimens subject to different surface modifications showed differences in the wear mechanisms under the boundary lubricating condition as well. Namely, the tempered steel specimen was mainly characterized by plastic deformation and pitting, the quenched specimen by grooves and delaminating, and the laser heat-treated one by polishing and mild adhesion. (c) 2004 Elsevier Ltd. All rights reserved.