The development of titanium alloys is limited by issues such as low hardness, poor wear resistance, and sensitivity to adhesive wear. Using laser cladding technology to create high-hardness wear-resistant coatings on the surface of titanium alloys is an economical and efficient method that can enhance their surface hardness and wear resistance. This paper presents the preparation of two types of nickel-based composite coatings, Ni60-Ti-Cu-xB 4C and Ni60-Ti-Cu-B 4C-xCeO 2, on the surface of TC4 titanium alloy using laser cladding. When the B 4C addition was 8 wt.%, the hardness of the cladding layer was the highest, with an average microhardness of 1078 HV, which was 3.37 times that of the TC4 substrate. The friction coefficient was reduced by 24.7% compared to the TC4 substrate, and the wear volume was only 2.7% of that of the substrate material. When the CeO 2 content was 3 wt.%, the hardness of the cladding layer was the highest, with an average microhardness of 1105 HV, which was 3.45 times that of the TC4 substrate. The friction coefficient was reduced by 33.7% compared to the substrate material, and the wear volume was only 1.8% of that of the substrate material. Abstract The development of titanium alloys is limited by issues such as low hardness, poor wear resistance, and sensitivity to adhesive wear. Using laser cladding technology to create high-hardness wear-resistant coatings on the surface of titanium alloys is an economical and efficient method that can enhance their surface hardness and wear resistance. This paper presents the preparation of two types of nickel-based composite coatings, Ni60-Ti-Cu-xB 4C and Ni60-Ti-Cu-B 4C-xCeO 2, on the surface of TC4 titanium alloy using laser cladding. When the B 4C addition was 8 wt.%, the hardness of the cladding layer was the highest, with an average microhardness of 1078 HV, which was 3.37 times that of the TC4 substrate. The friction coefficient was reduced by 24.7% compared to the TC4 substrate, and the wear volume was only 2.7% of that of the substrate material. When the CeO 2 content was 3 wt.%, the hardness of the cladding layer was the highest, with an average microhardness of 1105 HV, which was 3.45 times that of the TC4 substrate. The friction coefficient was reduced by 33.7% compared to the substrate material, and the wear volume was only 1.8% of that of the substrate material. Keywords: laser cladding; TC4 titanium alloy; nickel-based composite coating; microhardness